MIL-C-38999 Connectors, Series 2
Crimp Type Contacts
Rear Release; Glenair Designator Code F

Design Features:
  • Bayonet coupling design, quick disconnect, captive.
  • Eight shell sizes; Range: 8 through 24 (.500 to 1.500 diameter).
  • 16, 20, and 22 gage contacts, standard density and 22 gage high density arrangements; 3 to 128 contacts.
  • Shell ground available on MS and commercial part numbers.
  • Controlled accessory interface per MIL-C-38999 figure 11.
  • Cork and bottle primary interface and shell environmental seals, fluid resistant silicone elastomers.
  • Conductive and non-conductive finishes; electroless nickel, cadmium/olive drab, 500 hour salt life, and anodic.
  • Short barrel construction for minimum envelope.
Notes:
  1. Very short barrel, shell may strike pin contacts.
  2. Wire seal grommet controlled to maximum condition only, over compression will cause contact splaying.
  3. Same limitations as MIL-C-38999 Series 1.
  4. Same limitations as Series 1, exaggerated due to short barrel.

Back to Connector Accessory