When optimum shielding effectiveness and transfer impedance is a requirement, we recommend Glenair pre-assembled adapters and transitions. Common adapters and transitions are shown in this section. For configurations not shown, consult the factory.
Glenair offers hundreds of fitting design options not presented in this catalog. Consult the factory for other specific end fittings or adapters you may require.
Unless otherwise specified, the following dimensional tolerances will apply:
- .xx = ± .03 (0.8)
- .xxx = ± .015 (0.4)
Metric dimensions (mm) are in parentheses.
Product Selection Guide |
710-100Metal Bulkhead Adapters & Feed-Throughs for Series 72 & 74 Tubing and Series 75 Conduit |
Qwik Create |
 |
710-112Metal Split Rectangular Backshell for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-118Metal Split "Y" and "T" Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
|
710-120Metal Split "Y" and "T" Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-114, 710-115, 710-405Male Series 75 Tapered Pipe Thread Adapters |
|
|
710-116, 710-117, 710-406Female Series 75 Tapered Pipe Thread Adapters |
|
 |
710-106/107/370 and 710-108/109/371Metal "Y" and "T" Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
|
710-106/107/370 and 710-108/109/371Metal "Y" and "T" Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-077Metal Multi-Branch Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-093Metal Multi-Branch Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-493Metal Multi-Branch Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-444Metal Multi-Branch Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
713-100Metal Straight, 45°, and 90° Connector Adapters for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
713-102Metal Straight, 45°, and 90° M28840 Connector Adapters for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-652Multi-Port Special Purpose Transitions for Series 72 & 74 Tubing and Series 75 Conduit |
|
 |
710-318Composite Split "T" Junction Fitting for Series 72 and 74 Convoluted Tubing |
|
 |
710-319Composite Split "Y" Junction Fitting for Series 72 and 74 Convoluted Tubing |
|
 |
710-320Composite Split Junction Fitting Straight with 45° Branch Configuration |
|
 |
710-321Composite Split "+" Junction Fitting for Series 72 and 74 Convoluted Tubing |
